Plastic Smithing

  • Thread starter Thread starter robertmidwest
  • Start date Start date
Status
Not open for further replies.
R

robertmidwest

Guest
Any one have any experience plastic smithing?
 
Last edited:
Yes. I need to build some sheaves and pulleys for a project.

I was looking to see if anyone had some experience. I just put a few bottle caps together. It molding together pretty well. I just hope it doesn’t wallow out on the shaft.
 
Last edited:
(Please Note: This uploaded content is no longer available.)

This test run was about 7 bottle caps.
 
Status
Not open for further replies.
Back
Top