L
lak611
Guest
Wow, that is great. Thanks for the info. I guess the higher pitches for the pealing is because they use the smaller bells then. I noticed for the tolling for funerals the bells don’t swing back and forth, but they use the big bell. I noticed for the pealing that usually the medium and small bells are used. I also noticed most churches use three bells. My church has the electronic hammers (it’s a newer church, built in 1969). I have been to older churches that ring bells with ropes still. In fact, I was at a tour of an old Congregational church last year and got to go in the bell tower and inside the pipe organ as part of the tour.Pealing means swinging the bell back and forth by its yoke, as is normally done before Mass. Tolling involves single strikes from a hammer mounted underneath or to the side of the bell, which pops up to strike the bell while the bell itself remains still. This is common for funeral tolls, hour (clock) strikes, or for the Angelus. Neither pealing nor tolling can change the pitch of a bell, which always remains the same, but pealing it gives a Doppler effect and almost doubles the sound output.
Many American churches have bells that cannot swing (dead hung), but are struck with electric hammers. A peal in this case would involve repeated striking. A typical English peal (rare in America) would start with the bell upside-down, rotating 360º, and stopping again upside-down, to be reversed in the next rope pull. Normally, several such bells are sounded in mathematical sequences called change ringing. Eastern Orthodox churches perform similar rhythmic sequences on dead hung bells, while bells in Spain, Portugal, and Latin America are a combination of dead-hung bells rung in sequence and “esquilas” which are bells flipped end-over-end by people standing behind them, or occasionally a motor.
