Here is an excerpt from the current issue of the newsletter “The Week That Was”, available at
www.sepp.org
THIS WEEK:
By Ken Haapala, Executive Vice President, Science and Environmental Policy Project (SEPP)
The dominant news this week was the disastrous earthquake …
Yet to the American popular press, …
Though not all, many of the reports, pronouncements by anti-nuclear groups, and comments by politicians play on the scientific ignorance of the general population concerning nuclear energy. Although it is premature for a thorough analysis, a tentative review of what happened is useful for evaluating various reports and comments on modern nuclear power from uranium.
Number of the Week: Three to five percent as compared with ninety percent plus. In general, naturally occurring uranium is made up of about 0.7% of the U-235 isotope, with the balance of U-238 isotope. U-235 can support a fission chain reaction, but U-238 cannot. Most modern nuclear power plants use uranium oxide in which the percentage of U-235 has been increased to 3 to 5%. Uranium nuclear weapons require that the percentage of U-235 be about 90% or above. Very simply, the fuel used in a modern nuclear power plant cannot create a nuclear explosion, even if it is in the correct configuration and has an appropriate trigger.
All six of the reactors at the Fukushima Daiichi power plant are Generation II boiling water reactors of GE design. The oldest is …
In a nuclear plant, the heat from the nuclear reaction is used to…
Adding to the difficulty, if the fuel rods are exposed to air / steam, the zirconium that coats the rods combines so strongly with oxygen, that it can strip oxygen from steam, forming free hydrogen. Hydrogen is so chemically reactive that it is not found in the atmosphere. It burns rapidly in the atmosphere, giving the impression of an explosion.
…
The US Geological Survey reports …
Northeastern Japan is in a geologic …
Apparently, the earthquake destroyed the electric grid to which …
About an hour later, the tsunami overwhelmed the sea wall …
When plant workers opened valves to release pressure…
The earthquake and tsunami effectively destroyed regular communications…
What appears to be the most prolonged problem were the pools used for cooling the fuel assemblies. …
As of this writing, the latest reports are that the reactors are cautiously under control and that the temperatures of the cooling pools are being stabilized. Much of the instrumentation failed, but, based on theory, it appears that a few percent of each active reactor cores had damage.
Although not confirmed, if the above fairly reflects what took place, then it can be a basis to evaluate some of the more excited claims in the press and by anti-nuclear groups and politicians.
- The reactors withstood the earthquake significantly above designed strength.
- Although the primary source of electricity failed, initially the backup systems worked as required.
- The reactors withstood the tsunami which was above planned height.
- The tsunami disabled the diesel generated backup of electricity and the battery backup was either disabled or inadequate.
- The destruction of the standard communications between the plant operators and corporate and national leaders lead to a slow decision to flood the active reactors with sea water, which destroyed them.
- The observed “explosions” were chemical, probably burning of free hydrogen.
- Some meltdown of active reactors probably occurred.
- Some of the cooling pools overheated, probably exposing the fuel rods and giving off hydrogen and radioactive gases.
- Thus far, except for the immediate area around the reactors, the radioactivity released has been insignificant.
From this natural disaster, we can learn that properly built nuclear plants can withstand powerful earthquakes and tsunamis. But backup cooling systems and any on-site cooling pools must be protected from any after effects of an earthquake. Cooling pools should be separated from the reactors. Also, solid communications must be available in spite of scope of the natural disaster.
… The plant Fukushima plant had Generation II reactors that require active safety features such manually opening valves and electricity to run cooling pumps. Among other features, Generation III reactors have passive safety systems that do not require manual effort or electricity to run cooling pumps. The Westinghouse AP 1000, is one such example: “designed to achieve and maintain safe shutdown condition without any operator action and without the need for ac power or pumps. Instead of relying on active components, such as diesel generators and pumps, the AP1000 relies on the natural forces of gravity, natural circulation, and compressed gases to keep the core and containment from overheating.”
ap1000.westinghousenuclear.com/ap1000_saf…
As expected, many anti-nuclear groups and politicians are making much of the natural disaster to include calling for stopping the approval process of Generation III reactors.
In light of this tragedy, it is prudent that nations address the safety of their nuclear power plants. However, the anti-nuclear groups are so adamant in their opposition to this reliable source of electricity, that they oppose new nuclear plants that address the design flaws of plants built 40 years ago.
(Please see Articles # 1, 2, 3, & 4 and articles referenced under “Calming the Fears of Nuclear Energy,” “Fanning the Fears of Nuclear Energy” and “Responses and Issues Remaining.”